Nissan Charging Equipment Form

Please note that JET Charge and Nissan Motor Co. (Australia) Pty. Ltd. have partnered to deliver a standard installation on the following basis:

• The installation of a JET Charge supplied AC EV Wall Charger.
• 32 AMP Single Phase circuit for the EV charger (Maximum Demand/Current setting to be determined on site).
• Installation at a single dwelling and single storey house.
• Dedicated circuit approximately 20 Meters of wall ceiling mounted cable. (Inc, PVC surface mount conduit) (No more than 400mm of Flexible PVC Conduit in Visible Locations).
• Isolation switch mounted readily accessible to the EV Wall Connector.
• All associated electrical containment and hardware fixings for the installation.
• Installation of electrical circuit protection in switchboard.
• Installation of Type A RCD at origin of the circuit. Type A RCD’s protect against residual DC Current. (As per AS/NZS 3000:2018 Electrical Installation Wiring Rules).
• If required, then circuit Protection Arrangement (replacement of a double pole RCBO for single pole RCBO)
• If required, additional Enclosure for Circuit Protection if Switchboard is full.
• If required, a replacement of the Mainswitch with a Current Limiting device (circuit breaker). Excludes Electrical Inspection costs.

A standard installation does not involve:

• Apartment installs
• Three phase charger installation
• Major Circuit Protection Arrangement (Replacement of multiple pole RCBO’s)
• Electrical Inspection Costs (required for prescribed works)
• Major electrical upgrade works
• Consumer / Sub Main Upgrade
• Switchboard Replacement
• Trenching Civil Works
• Structural Impedance (e.g. lifting roofing sheets)
• Asbestos Removal